Search results

I put one on the asphalt,2004 warrior they are a heavy sled .I turbod it ran a 136 inch track . Need to do alot to the engine billet caps on carbs different clutch with alot more weight and more ran on 116 gas. To expensive to be competitive. Makes a good 10 sec sled.I ran in the 9.9's with a...

woulld putting a 1 nipple wastegate pot be the thing to do? One of the nipples says its boost and the other say it has vaccume.Can i just put a nipple on the neck of the turbo just before the filter,drill and tap a 1/4 hole? I see on some of the pics on Powderlites has one in that location.

so I hook the gauge off from the hoses from the back of the carbs. Then I need to get a regulator and hook the vacuum side of the actuator to it and the boost side of the turbo. Does it matter where I drill and tap the turbo at on the boost side?What is the valve in the picture on the side of...

Putting a Garret 28rs on a 04 Rx Warrior and have a few Questions. The 2 hoses that come off from the manifolds just before the carbs, on number 1 and 4, where do they go? The 2nd question, one the vacume on the turbo there are 2 lines where do they connect? The last question is what is done...

Does anyone know where to get instulation instructions for a gt28rs turbo on a 04 Rx1? Hooking up cooling lines etc.

Thanks for the help on this,the screw I was refuring to was to loosen or thighten the cable sometimes to tight it will activate the tors. I just had to jump two wires and was back running. Thanks again

Hey Thanks I finally figured it out, I took the controls completely off so I looped it in the harness. Thanks again :flag:

How do you bypass the kill switch on the handle bar. Put a new throttle on and need to bypass the kill switch because it is part of the tors system. Any one ever did this before? Its on my asphalt sled 04 Rx warrior.

I did put a new throttle on it but the cable is loose. I turned the tors screw in and out and it got so it would just die out. I would let off the throttle and it would idle again. Is there a certain amount of turns this screw should be? How do ya know when it is ajusted right?

I have a Rx Warrior that I run on the asphalt. I took the stock handle bars and controls off from it and replaced them with a set of drag bars and 3' risers. Kept the stock brake set up but replaced the throttle with one from Wahls. Now the sled will only idle. when I hit the gas it sounds like...

Can some one tell me whats wrong I put a kill switch on my 2003 Rx1 Warrior and it works backwards. Sled stops with tether on and runs when it is off. Just the oppisite of what I need. Do I need a open or a closed switch? Hooked it up to the wires frm the kill switch on the handle bars. Brown...