Search results

Thanks

Who is FPP lol

What Springs are you running

Is this only happening two tracks with the clips on the inside of the rails?

I have it , I never received it till now was gone sled was away so we're just about to dig them out and I'll get it done

Yes my bearing is still all so good 4500 miles but I noticed a little bit loose on the shaft so was going to take shaft out and go over things thought I should put a new a new bearing in at the same time I guess

So will the 6009 fit tighter without the c3 on the end

Hi there just wondering what number or brand bearing most are using for the drive axle on the brake side for best last and fit

Is your clutch alignment according to hurricane tool?

I Wonder would it Kurt to ad more clips on the outside?

Think it’s a 153-162 thing

Maybe it’s only the bigger tracks that the clips are this way

This has never been apart, and only started doing this lately

It’s getting pretty deep

What’s the best Bearing to use ?

And I also noticed drive speedo sensor wear into the case cover, starting to wonder if the axle is moving side to side a bit,it’s getting pretty deep as well was the wear inner side off chaincase cover

No not the normal wear ,, it’s the whole insides not a mark in both my friends sleds

Any one else notice wear on the inner sides of there sprockets from the clips on the track?

Just wondering what happened to the tester? I didn’t receive it

Where could I order these bushings