Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
We are no longer supporting TapaTalk as a mobile app for our sites. The TapaTalk App has many issues with speed on our server as well as security holes that leave us vulnerable to attacks and spammers.
ONE THING I DID NOTICE WAS WHEN I BLOW IN THE LINE FROM THE INNERCOOLER TO THE CARB ALL FOUR SLIDES DONOT OPEN EVENLY TWO GO UP BEFORE THE OTHER TWO NOT SURE IF THIS IS CORRECT BUT DUE TO THE T VERSE THE ELBOW I THINK THIS IS CORRECT BECAUSE THE ELBOW IS GOING TO PRESSURIZE BEFORE THE T WILL BUT...
will a exhaust leak up front mess with anything sound s like i have a exhaust leak at motor now, wouldnt think it will effect getting this thing to run right working on list of thing that im checking get back with out come.
thanks guys where can i get the billet t s .if im understanding there is a jet in the pilot tube ,or is it in the bottom of the charge tube the one in the bottom of the charge tube is a 400.
have sled all together installed boost guage,and water temp guage,let sled run up to 125 degrees and tried running it on the grass.Sled goes about 20 to 30 foot and starts spudering im not seing any boost on the guage seem when it starts to make boost it wants to die out, possible over...
M BARRY DO YOU THINK I SHOULD PUT A FUEL PRESSURE GUAGE IN LINE AND SEE IF THE PRESSURE FALLS OFF OR SHOULD I TRY RUNNING IT ON THE GRASS AND QUIT RUNNING IT ON THE STAND MAYBE ITS FINE WHEN IT ON THE GROUND WHEN ITS UNDER A LOAD. I WILL INSTALL BOOST GUAGE & WATER TEMP I SEE ENOUGH TURBO SLEDS...
m barry is it possble that may be the problem that running itt on a stand is not building boost so the preasure is not getting to the carb and it is starving the carbs after a few minutes of running it,I figured it was the safest way if run it on the snow or grass and it goes lean i probably...
new question, same issue. we went through the carbs and they're claen with the stock jets. i did disconnect the tors - no change. she does run good for a couple min. on a stand at a constant 6-7k rpm before breaking up and dying. when it died i pulled a plug and it looked like it was carbon...
thanks mbarryracing it sounds like i have it hooked up right what would cause the over fueling is there a adjustment on that regulator this a kit i bought off the internet last week i have no instructions my brother and i installed with neither of us ever owning a turbo sled before .i have a...
I just installed a bender turbo on my sled this weekend istarted it yesterday without the innercooler on ran good idle fin rev up good, installed inercooler sled idle fine but when i try to rev it up it starts spudering like its on a rev limiter, was i suposed to disconnect the tors or is the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.