Search results

I have had problems with Knock light all year long. Have been working with Dave and he is convinced its a boost leak in my case. Building my own sensor tonight. I used the one we have all been passing around on this site. This is frustrating as hell. Cannondale I'll call you tonight to discuss...

Ready for snow

Tester is sent back. One leak on the top of bov. Works great

Going to be mailed to me

Is this still available? I Would be interested

I see the part numbers on page 1. Are those part numbers the ones needed. 32 pages is a lot to go thru and possibly miss something. Thanks ahead of time.

I found that 160 number on the dyno also. 140 on dyno was too low. I want to jump up to 180 for a couple passes just to see.

I am running a 136 track on my 137 viper. I changed drivers. Its a tight fit and you cannot run bigger wheels than stock in the rear, they will rub. on coupler shaft.

There are some other posts with similar info but those numbers did not work for me. Tonight I sat down and figured out the numbers for voltage that corresponds to the temp on my 2015 viper LTX. I only have 3 values so far. but it seems to work in the garage anyhow. I tried with more values in...

Follow up to this thread. I just figured out the numbers for voltage that corresponds to the temp on my 2015 viper LTX. I only have 3 values so far. but it seems to work in the garage anyhow. I had it up to 160 and down to 80 and it is within a degree to what is shown on the dash instrument...

Anyone have input on gearing for 500' grass drags? Currently stock 24-50. 2015 ltx. 136" R track 2.52 10 tooth drivers. PCV with wideband and POD300. Ulmer air intake K&N's D&D clutching. 9200 rpm Looking to get to about 85 mph and run out of gear. I am a bit sceptical of the calculators. I am...

Anyone know if ulmer sells the k&n kit yet? Have called and left messages and sent messages on here, but no reply.

Is anyone running a 13.5" wide track on a stock Viper skid? I'm looking to swap a 13.5" x 136" x .525 Camoplast 9937R. I have the driver assembly swapped with the cat 10 tooth 2.52 pitch. Any advice on what modifications need to be done. 2015 Viper LTX 137"

Yes it is the same on my 15 ltx

Thanks. I'll look into that.

Looking to remove the stock shaft and replace it with a new one that has 10 tooth 2.52 drivers. Need the 2.52 drivers to run a 136 speed track on grass and ice. Anyone have advice on where i can get it as an assembly? Sled is 2015 Ltx Viper.