Search results

I'm thinking of selling my 2003 RX-1 any ideas on what an asking price(ballpark) may be? The sled has 5,xxx miles on it. No rips or tears in the seat, body panels in excellent condition. Front A-arms have a few paint chips on them but they are not bent. The track will need to be replaced it...

Thanks for sharing!!!!!!!

That is sweet looking!!!!!!

Got in a hurry and I didn't notice there was connector for the carb heater wiring harness. I should have looked a little closer. I know better!

If your out of N20 and the system is working correctly your engine should stumble due to the extra fuel I would think.

Try: UStrailmaps.com I personally have not used them but would like to give them a try.

Thanks for help guys

Where on the Rx-1 is good place to pick up a switched 12V source? I know I could wire directly to the battery but would rather have the power cut when the key is off. PS: this will be for GPS

I have one of these (Garmin Legend- color). I bought it earlier this year and love it. I am planning on using it this year on the sled. A friend of mine has one on his sled and he loves it. They are pretty simple to use. Just get aquainted with it before you go ride. I learned to use it...

I broke one of my carb heaters last night. How important are they to have all of them?

OK, now I see them. I was under the impression that the allen screws were on the weight pins only. Again thanks for the help guys!!!!!!!!

I just bought a stageIII clutch kit from Ulmer Racing. I've removed the bolt that holds the rollers but am unable to slide the pin out. Are the pins pressed in place or should they just slide out. Is there anything I am missing?

Dropped the suspension tonight and found the heat shield on one of the y-pipes loose so I took them out. All the clamps are nice and tight so I guess I'll put it back together. Thanks for the help!!!!!!!!

Thanks for the help and wish me luck I'm dangerous with my sawzall!!!!! I'll sync the carbs as well. I've got a ECP going this weekend.

My 03 Rx-1 has an bad rattle/vibration at idle. I read a post on here a while back and someone stated that it wasn't a heat shield but the clamps and gaskets for the exhaust. I pulled the gas tank last night and it looks like the clamps on the manifolds are tight. There dosen't seem to be...

On my 97-SX the spring broke. Fixed it once myself(new spring) it broke halfway through the next season. Then I removed the recoil assembly and had a dealer put a new spring in it and wind it. They told me the rope was too short and put a longer on in as well. The mechanic told me that...

Great dependable sled and engine. I'm with yammie3687 I think its a little pricey for a six year old sled. Just my opinion.

Thanks, I sent you a pm.

Can someone post pictures of thier evac setup with a ECP kit. or even a Lightning Pro evac setup as well. Any pictures/help would be greatly appreciated.

OK, Good YAMAHA is there I made sure it still worked before i sent the link.