???? Changing Rollers on RX-1 primary clutch

[hotrodsrx]

I just bought a stageIII clutch kit from Ulmer Racing. I've removed the bolt that holds the rollers but am unable to slide the pin out. Are the pins pressed in place or should they just slide out. Is there anything I am missing?

 

[suprfst]

You have to loosen the two set screws as well,that hold the pin from rotating.I think they are 2.5mm but im not positive.

 

[Turk]

Yep; 2 X 2.5 small allens that the japs tightened to about 1,000,000 ft pounds on some of em!!!

 

[hotrodsrx]

OK, now I see them. I was under the impression that the allen screws were on the weight pins only.

Again thanks for the help guys!!!!!!!!