03 RX1 MTN Measurements Needed

[151Viper]

I have an 02 Viper 121 that I am converting into a low budget mtn sled and I got a 151 skid out of a 03 RX1 Mtn and I need some measurements. I am looking for the distance from the center of the drive shaft to the center of the front arm of the rear suspension. I suppose this will only work if the drivers are the same size. I have 8 tooth drivers but I am not sure what an RX1 comes with. Any help would be appreciated.

Thanks

 

[151Viper]

TTT

 

[GUKROKIT]

The measurement from center of trackshaft to center of front arm is 14inches.This is on the 03rx-1 mountain.

 

[151Viper]

Thanks for the measurement gukrokit. I had someone pm me and they have a template of this exact transplant from mountain performance and they are sending it to me to use. Hopefully the template will solve any issues that I may have. I will double check with your measeurement though. I appreciate the reply.