2005 Yamaha Vector Riser??

[speedy123]

Looking to add a 2" powermadd riser-looks like the stock cables are long enough-however there is a "notch" on the new riser?

How would I install the riser and how much should I torque the bolts?

Also should I use all of the hardware that came with the riser or use any of the factory parts i.e. nuts/washers?

Thanks for any advice!

 

[xt_gt]

yes the riser works & cables are long enough. i have installed this riser on my dads 05 vector. i don't remember a notch on it or which hardware i used, but i will go take a look & get back to you. not sure if it matters much.

 

[Bluebullet]

Speedy, I tryied a 2 inch power made riser on my apex and could not find long enough bolts anyware to get it to work. I ended up buying a mountain riser off a guy on here and worked like a champ ( came with all the hardware) Read my post on installation for tips. Cables are long enough as long as you losen the wraps and get slack before switching the riser out, I pulled a hot grip wire out and had to replace the grip heater.

 

[speedy123]

Thanks Bluebullet trying to raise the bars as my son wants em' higher-looking forward to the taller bars on my 2012 this season!

 

[xt_gt]

just reused the factory bolts