2008 Apex seat pan on 2012 vector

[henseljg2]

Ok, so I have a 2008 Apex seat pan with a wrp seat on it and I'm having difficulty getting good it installed on the 12 vector. I have done a million seat installs and it seams like the seat hooks aren't low enough to hook the gas tank. Anyone else run into this?

 

[henseljg2]

Ok. I'll leave this post up for science. Looks like the Apex and Vector seat pans are different. not quite sure why they changed but they are definitely different. I put the vector seat on an Apex and it looks ok but is sloppy as hell. Looks like this applies to 12 and up vectors.

 

[hibshman25]

Eps sleds have a different gas tank. Tank is taller in back so seat pan changed.

 

[theCATman]

Subtle changes from Deltabox 2 vs 3. That's your problem.

Sent from my SM-G930R4 using Tapatalk

 

[4strokeluvr111]

When I installed a WRP seat on my 14 Vector I had to carve out the foam in the bottom of the seat so that it would fit over the gas tank "bubble". WRP told me that I was going to have to do this.

Maybe my thread here will help? http://ty4stroke.com/threads/wrp-2-seat-install-on-a-2014-vector-ltx.140368/

 

[henseljg2]

When I installed a WRP seat on my 14 VEctor I had to carve out the foam in the bottom of the seat so that it would fit over the gas tank "bubble". WRP told me that I was going to have to do this.

Maybe my thread here will help? http://ty4stroke.com/threads/wrp-2-seat-install-on-a-2014-vector-ltx.140368/

Good to know. I'm planning on grabbing another kit.

 

[4strokeluvr111]

WRP will do the "carving out" of the seat and seat cover install for no charge if you send them your seat pan and cover. If I was doing it all over again, I'd spend the shipping cost $$ and send the stuff to them and let them do it.