Adjusting TPS (Throttle Position Sensor)

[Iceman57]

I have to replace my TPS and the manual doesn't cover the TPS adjustment. Does anyone know the procedure? Any help would be appreciated.

 

[1CrazySledder]

Here ya go. I had to replace mine last season....

http://www.ty4stroke.com/viewtopic.php? ... hlight=tps

 

[Iceman57]

Here ya go. I had to replace mine last season....

http://www.ty4stroke.com/viewtopic.php? ... hlight=tps

I'm not familire on how to use the dash to adjust the TPS, could you walk me through it?

 

[1CrazySledder]

-Turn the main switch to "OFF" and set the engine kill switch to "ON".
-Simultaneously press and hold the "SELECT" and "RESET" buttons for 8 sec.
-After selecting "dl", Simultaneously press and hold "SELECT and "RESET" for 2 or more seconds.

You use the "SELECT" and "RESET" buttons to advance or go back through the code number. They are 01 through 70.

TPS is 01.

Get the sensor in a spot where it looks close and use the throttle to see the value. You may have to move the sensor a little to match the correct value.

No throttle: 16%
Full throttle: 96%

Tighten up the two bolts, Turn the main switch to "OFF" to cancel this and put the gauge back to normal operation.

 

[Iceman57]

-Turn the main switch to "OFF" and set the engine kill switch to "ON".
-Simultaneously press and hold the "SELECT" and "RESET" buttons for 8 sec.
-After selecting "dl", Simultaneously press and hold "SELECT and "RESET" for 2 or more seconds.

You use the "SELECT" and "RESET" buttons to advance or go back through the code number. They are 01 through 70.

TPS is 01.

Get the sensor in a spot where it looks close and use the throttle to see the value. You may have to move the sensor a little to match the correct value.

No throttle: 16%
Full throttle: 96%

Tighten up the two bolts, Turn the main switch to "OFF" to cancel this and put the gauge back to normal operation.

Thanx........Much appreciated

 

[Renaud]

-Turn the main switch to "OFF" and set the engine kill switch to "ON".
-Simultaneously press and hold the "SELECT" and "RESET" buttons for 8 sec.
-After selecting "dl", Simultaneously press and hold "SELECT and "RESET" for 2 or more seconds.

You use the "SELECT" and "RESET" buttons to advance or go back through the code number. They are 01 through 70.

TPS is 01.

Get the sensor in a spot where it looks close and use the throttle to see the value. You may have to move the sensor a little to match the correct value.

No throttle: 16%
Full throttle: 96%

Tighten up the two bolts, Turn the main switch to "OFF" to cancel this and put the gauge back to normal operation.

This proc edure is good for apex?2009