Fast Lane
Expert
- Joined
- Feb 6, 2020
- Messages
- 250
- Age
- 47
- Location
- Winnipeg
- Country
- Canada
- Snowmobile
- 2007 Yamaha Nytro ER
- LOCATION
- Winnipeg
Why does the top of the belt come off? This is the second time its done this. Heat? Old age? Curious what you guys figure.
74Nitro
VIP Member
- Joined
- Feb 18, 2013
- Messages
- 5,265
- Age
- 52
- Location
- Dublin Ontario
- Country
- Canada
- Snowmobile
- 2019 Sidewinder LTX
Put a straight edge on your primary sheaves.
thrasher
TY 4 Stroke Junkie
- Joined
- Nov 22, 2006
- Messages
- 694
- Location
- Ottawa Valley, Ontario
- Country
- Canada
- Snowmobile
- 06 Vector RS ER
Typical Yamaha belt issue. Generally after a long run at near top speed the belt heats up and fails. You can feel it start to delaminate on your left foot before it explodes. However, I would usually get 2-3 thousand kms out of the Yammi belts.
Fast Lane
Expert
- Joined
- Feb 6, 2020
- Messages
- 250
- Age
- 47
- Location
- Winnipeg
- Country
- Canada
- Snowmobile
- 2007 Yamaha Nytro ER
- LOCATION
- Winnipeg
The belt has 4500 kms on it I should add. I felt a vibration then smelt some rubber.
thrasher
TY 4 Stroke Junkie
- Joined
- Nov 22, 2006
- Messages
- 694
- Location
- Ottawa Valley, Ontario
- Country
- Canada
- Snowmobile
- 06 Vector RS ER
That belt had done you well at 4500 kms, was at the end of its life.
- Joined
- Jun 1, 2004
- Messages
- 7,730
- Location
- sudbury on
- Country
- Canada
- Snowmobile
- 2016 apex xtx
2011 apex xtx
2009 phaser rtx/x
1997 et410t/r
1988 vk 540
i usually only get around 2-3000 km on a belt on average without towing anything.
Fast Lane
Expert
- Joined
- Feb 6, 2020
- Messages
- 250
- Age
- 47
- Location
- Winnipeg
- Country
- Canada
- Snowmobile
- 2007 Yamaha Nytro ER
- LOCATION
- Winnipeg
Interesting. I wasn't sure if it was a belt issue or an alignment issue but it just could be cause of miles on it. I've never had a belt blow clean through. Just the tops come off. I have always ran the 8DN belt.
biffdotorg
VIP Member
- Joined
- Dec 2, 2008
- Messages
- 2,182
- Location
- Pelican Rapids, MN
- Website
- www.biff.org
- Country
- USA
- Snowmobile
- Apex XTX and Viper LTX SE
- WEBSITE
- www.biff.org
No, this is not normal. It's normal for a high heat failure, but not normal to get so few KM's out of a belt.
Two Apex with 8DN and over 12,000 miles on stock belt. Only changed on my latest Apex due to pulling the viper out on frozen ground and the studs hooked up, fried the belt. (stupidity) Viper even has an 8DN with thousands of miles on it. I carry a spare, but have no intentions of changing it till it shows signs of wear.
Two Apex with 8DN and over 12,000 miles on stock belt. Only changed on my latest Apex due to pulling the viper out on frozen ground and the studs hooked up, fried the belt. (stupidity) Viper even has an 8DN with thousands of miles on it. I carry a spare, but have no intentions of changing it till it shows signs of wear.
Fast Lane
Expert
- Joined
- Feb 6, 2020
- Messages
- 250
- Age
- 47
- Location
- Winnipeg
- Country
- Canada
- Snowmobile
- 2007 Yamaha Nytro ER
- LOCATION
- Winnipeg
That is some crazy miles on an original belt!
This is a picture of my first belt from many years ago. It was old and rotten. It blew up near the North West Angle.
This is a picture of my first belt from many years ago. It was old and rotten. It blew up near the North West Angle.
74Nitro
VIP Member
- Joined
- Feb 18, 2013
- Messages
- 5,265
- Age
- 52
- Location
- Dublin Ontario
- Country
- Canada
- Snowmobile
- 2019 Sidewinder LTX
Show a pic with a straight edge on both sides.Why does the top of the belt come off? This is the second time its done this. Heat? Old age? Curious what you guys figure.
View attachment 175611
- Joined
- Jun 1, 2004
- Messages
- 7,730
- Location
- sudbury on
- Country
- Canada
- Snowmobile
- 2016 apex xtx
2011 apex xtx
2009 phaser rtx/x
1997 et410t/r
1988 vk 540
the gf gets better milage out of a belt than i do as my apex's are clutched agressively and i am more of a throttle jockey than she is. she tends to get 3-4000 mi how she drives if i do not run that sled too much.No, this is not normal. It's normal for a high heat failure, but not normal to get so few KM's out of a belt.
Two Apex with 8DN and over 12,000 miles on stock belt. Only changed on my latest Apex due to pulling the viper out on frozen ground and the studs hooked up, fried the belt. (stupidity) Viper even has an 8DN with thousands of miles on it. I carry a spare, but have no intentions of changing it till it shows signs of wear.
SumpBuster
TY 4 Stroke God
- Joined
- Jul 18, 2003
- Messages
- 2,353
- Location
- Carlisle, NY .
- Country
- USA
- Snowmobile
- 18 sidewinder; 06 Apex RTX
Stubbs
TY 4 Stroke Master
- Joined
- Nov 7, 2006
- Messages
- 1,120
- Age
- 44
- Location
- Uxbridge, On, Can.
- Country
- Canada
- Snowmobile
- ‘16 Apex XTX with 137” Mono II
+ other gooodies
- LOCATION
- Uxbridge ON
The three holers aren’t nearly as easy on belts or clutch parts as compared to the quads. I give my Ape a new 8DN every other season just so she knows I still like her and appreciate all she does for me.No, this is not normal. It's normal for a high heat failure, but not normal to get so few KM's out of a belt.
Two Apex with 8DN and over 12,000 miles on stock belt. Only changed on my latest Apex due to pulling the viper out on frozen ground and the studs hooked up, fried the belt. (stupidity) Viper even has an 8DN with thousands of miles on it. I carry a spare, but have no intentions of changing it till it shows signs of wear.
Fast Lane
Expert
- Joined
- Feb 6, 2020
- Messages
- 250
- Age
- 47
- Location
- Winnipeg
- Country
- Canada
- Snowmobile
- 2007 Yamaha Nytro ER
- LOCATION
- Winnipeg
I'm in Las Vegas right now for work but when I get home I'll get a straight edge out.
biffdotorg
VIP Member
- Joined
- Dec 2, 2008
- Messages
- 2,182
- Location
- Pelican Rapids, MN
- Website
- www.biff.org
- Country
- USA
- Snowmobile
- Apex XTX and Viper LTX SE
- WEBSITE
- www.biff.org
It's the very reason I laugh when folks debate over what third party belt to use. The 8DN is the cheapest and longest lasting option out there. And it can handle the Hp thrown at it.The three holers aren’t nearly as easy on belts or clutch parts as compared to the quads. I give my Ape a new 8DN every other season just so she knows I still like her and appreciate all she does for me.
My first Apex was Ulmer clutched, as well as the Viper with plenty of bolt on mods. But my XTX is about as stock as it gets. Heck, I finally sent my clutches in to get fully serviced before last season at around 13,000 miles. As the engagement as not like it should have been. Still not a belt issue, but the primary was in need of some well deserved love
Similar threads
- Replies
- 1
- Views
- 2K
-
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.