shadbehnke
Newbie
- Joined
- Nov 6, 2015
- Messages
- 13
- Reaction score
- 1
- Points
- 33
- Location
- Wisconsin
- Country
- USA
- Snowmobile
- 2009 Phazer RTX 136''
Replacing my upper a arm on the clutch side and its a pain in the A** to get to that rear bolt....Any tips or do I have to take all the plastics off. Thanks
Voda2000
TY 4 Stroke Junkie
- Joined
- Nov 15, 2006
- Messages
- 592
- Reaction score
- 73
- Points
- 778
- Location
- Winnipeg Manitoba
- Country
- Canada
- Snowmobile
- 2007 Phazer GT 136"
Pull the air box.
Mooseman
I'm not all knowing. Post your question in forum.
- Joined
- Nov 3, 2009
- Messages
- 4,115
- Reaction score
- 1,084
- Points
- 1,733
- Location
- Greely, Ontario
- Country
- Canada
- Snowmobile
- '07 Venture MP (gone)
'07 Phazer FX (gone)
'09 Phazer GT (gone)
'10 RS Venture GT (My current ride)
'10 Nytro FX (son's)
- LOCATION
- Greely, ON Canada
That and use the closed angled end of a wrench.
Voda2000
TY 4 Stroke Junkie
- Joined
- Nov 15, 2006
- Messages
- 592
- Reaction score
- 73
- Points
- 778
- Location
- Winnipeg Manitoba
- Country
- Canada
- Snowmobile
- 2007 Phazer GT 136"
Good point. I think for the last one I did, I put some masking tape on the back side of the closed end to hold the nut while I got the bolt started on reassembly.
Purplecoffin
Pro
Pia. I usually pull the small plastic piece behind the tool bag and cuss while I use the closed end there and a rachet on the other side.
