Hoxtongue
Extreme
- Joined
- Jan 23, 2014
- Messages
- 88
- Reaction score
- 11
- Points
- 158
- Location
- Ontario
- Country
- Canada
- Snowmobile
- 2006 Yamaha Apex RTX
I installed an after market limiter strap on my 06 RTX (bought it without the OEM one) and I have it on the tightest settings and when the sled is on the ground I still have a good two inches of slop.
Can someone take a pic of theirs resting to see if it should be flexed, or snug. So far it's been handling fine, but was curious to see if I may have to drill some new holes to tighten it up a bit.
Can someone take a pic of theirs resting to see if it should be flexed, or snug. So far it's been handling fine, but was curious to see if I may have to drill some new holes to tighten it up a bit.
FRANK
Veteran
- Joined
- Dec 21, 2006
- Messages
- 37
- Reaction score
- 7
- Points
- 688
If I remember correctly your RTX is a Mono skid. Limiter strap on both my 06 & 11 Apex's is always very slack even tightened up 2 holes. Your front & rear pre-load will have a small effect on this also. If it handles well as is, don't worry be happy!
