Limiter Strap Question

[Hoxtongue]

I installed an after market limiter strap on my 06 RTX (bought it without the OEM one) and I have it on the tightest settings and when the sled is on the ground I still have a good two inches of slop.

Can someone take a pic of theirs resting to see if it should be flexed, or snug. So far it's been handling fine, but was curious to see if I may have to drill some new holes to tighten it up a bit.

 

[FRANK]

If I remember correctly your RTX is a Mono skid. Limiter strap on both my 06 & 11 Apex's is always very slack even tightened up 2 holes. Your front & rear pre-load will have a small effect on this also. If it handles well as is, don't worry be happy!

 

[Hoxtongue]

If I remember correctly your RTX is a Mono skid. Limiter strap on both my 06 & 11 Apex's is always very slack even tightened up 2 holes. Your front & rear pre-load will have a small effect on this also. If it handles well as is, don't worry be happy!

Thanks for the quick reply, appreciate it. Correct, it is the Mono.