Max Lugs Size 2010 Vector ltx gt

[Daonlyone74]

Not sure if its been discussed but couldnt find anything yet.

Does anyone know what the max lug height can be on a stock 2010 vector ltx gt? I know stock is 1.25". Will a 1.5 or 1.6" fit without modification?

If they cant fit what would need to be done to fit one? Im a newbie to these never sleds and modifying them.

 

[darv]

1.5

 

[Daonlyone74]

1.5

Someone local to me has a used camoplast 0602-904 in good shap which comes in at a 1.6 lug. Would that clear is that pushing it?

 

[pdiddy]

Keep in mind, even the 1.25 with studs will contact the rear heat exchanger without additional tunnel protection.

 

[Daonlyone74]

Keep in mind, even the 1.25 with studs will contact the rear heat exchanger without additional tunnel protection.

I have tunnel protection. Is there any modifications that can be done to properly fit larger lug tracks or is this sled stuck to keep a 1.25"

 

[Stubbs]

Unless you remove the tunnel protectors 1.5” is as tall as you can squeeze in there. Forget studs with a 1.5” track as well, you’ll have mega contact trying to run them and cause tons of damage unless you swap out to 8 tooth drivers and space the skid down out of the tunnel.

 

[maim]

1.5" will have clearance. 1.6" will be really close. just spent 2 hrs looking at the tunnel protectors on the cooler by the drivers on my 11 with the 1.5" track.

 

[Daonlyone74]

1.5" will have clearance. 1.6" will be really close. just spent 2 hrs looking at the tunnel protectors on the cooler by the drivers on my 11 with the 1.5" track.

Do you still have the protectors on with the 1.5" ?

 

[maim]

yes i do.

 

[darv]

it is the front you need to worry about if you put a 1,5 no studs

 

[Stubbs]

The track runs pretty close to the protectors everywhere with a 1.5”, just hung one on a ‘14 Vec. with the protectors left in.