Yes we've got lots of TS HD oil tanks in stock!
If you spray it good and clean with break cleaner. Give it a few minutes and if it's cracked a black line will appear. Also look where the tabs mount.
The tanks are very weak and a failure would be a very expensive mistake.
If you spray it good and clean with break cleaner. Give it a few minutes and if it's cracked a black line will appear. Also look where the tabs mount.
The tanks are very weak and a failure would be a very expensive mistake.
DelgatyXTX
Expert
Hi guys. I found my leak fortunately. I pulled the side/bottom pan and cleaned the bottom of the tank with brake cleaner really well and watched for a leak - nothing. Let the sled run for about 4-5 minutes till the oil tank got hot to the touch and waited. Then... drip... drip... Got under it and ran my finger along the bottom of the tank - nothing. Ran in along the joint between the elbow and tank and there it was. I checked the bolts and was able to tighten them a bit more, maybe a 1/2 turn each and it may be my imagination but it looked to close a bit. Cleaned it up good and I'm going to check it again in a bit for more drips. If there is I'm going to drain the tank, pull the elbow, replace the o-ring and that should solve it.
Thanks for the help though, it was good to find out about the problems with the tank and know what to look for if I get another leak somewhere else down the road.
Thanks for the help though, it was good to find out about the problems with the tank and know what to look for if I get another leak somewhere else down the road.
DelgatyXTX
Expert
O-ring was damaged, going to pick up a new one at the dealer right away.
