STUDS....what to do...

[sleddingfarmer]

oh I gotcha. No I won't be attending, thats like a solid 5-6 hours away from where I'm at.

I'm from a town actually called "milltown". That must be a common nickname for Milwaukee cause I get that a lot lol

 

[mullisha nytro]

I've. Been tossing the idea of studding up around to, but my question is running them up the middle will it rub the shock or jus set them up far aparr in the middle

 

[Daranello]

114 Top Gun Studs with Polimer backers

Not one bent or broke after 5000km, riding lots of dirt, rocks, road and racing...

 

[KHEXX]

114 Top Gun Studs with Polimer backers

Not one bent or broke after 5000km, riding lots of dirt, rocks, road and racing...

What made you decide on 114 and what size studs did you go with?

 

[mullisha nytro]

Thanks daranello I like your set up. That's what I was looking for

 

[Daranello]

http://www.fasttractraction.com/topguncarbide2.htm

1.375" with XL round backers. I think 2 per row it's pleaty.

Anything more just slows you down on top end. Plus it's still nice to break it free.
On hard glare ice it will loss traction at over 100mph.

 

[mullisha nytro]

Haha everyone loves to slid a little, thanks for the link ill be looking into it. They have colored backs still correct

 

[KHEXX]

http://www.fasttractraction.com/topguncarbide2.htm

1.375" with XL round backers. I think 2 per row it's pleaty.

Anything more just slows you down on top end. Plus it's still nice to break it free.
On hard glare ice it will loss traction at over 100mph.

Did you make up your own pattern? Or where did you find it? Thanks in advance...I like this setup!!

 

[KHEXX]

I just noticed you have an XTX...I have a 121....

 

[Daranello]

http://www.fasttractraction.com/topguncarbide2.htm

1.375" with XL round backers. I think 2 per row it's pleaty.

Anything more just slows you down on top end. Plus it's still nice to break it free.
On hard glare ice it will loss traction at over 100mph.

Did you make up your own pattern? Or where did you find it? Thanks in advance...I like this setup!!

It's the Woodies 96 stud pattern. Just added more 6 more rows to hit 114

 

[dilligaf]

http://www.fasttractraction.com/topguncarbide2.htm

1.375" with XL round backers. I think 2 per row it's pleaty.

Anything more just slows you down on top end. Plus it's still nice to break it free.
On hard glare ice it will loss traction at over 100mph.

Nice work. If I were to run studs again, this would be it.