Who's running asphalt this year?

[stoutner]

Who's running asphalt this year? Where are you running? Running anything special?

I should be running my Apex again with just a little bit of Nitrous at Esta In Cicero, NY.

 

[hlmrx1]

I will be, see,,,,,,
http://www.ty4stroke.com/viewtopic.php?t=53851

 

[lakercr]

Moi

 

[hlmrx1]

Moi

Jim, je ne savais pas que vous parlé le français!!!!!

 

[lakercr]

Comment est-que tu dis "yup" en francais?

 

[hlmrx1]

Comment est-que tu dis "yup" en francais?

Oui

 

[monker]

I'll be out here and there again.

Just finishing up installing a radiator in the front that will hopefully let me eliminate the heat exchangers along the tunnel.

 

[SRXMAGIC]

SEE YOU GUYS THIS YEAR!!
________
Mirada

 

[monker]

I haven't been out yet, but hopefully in a couple weeks. Just about finished up with installing my radiator. Hopefully this will allow me to completely remove the heat exchangers. Maybe even run without a cool down cart, but that might be pushing it.

 

[700Canuk]

Back again this year with the 05 RX. No changes to date other than clutching. It may see some low buck improvements as the year goes on... as I would really like to target a 10.5x pass with good air a little later in the year.

 

[lakercr]

Monker - what's the rad out of?

 

[monker]

Monker - what's the rad out of?

yfz 450. You can find them on ebay pretty easily.

 

[stoutner]

I still haven't even started getting mine ready yet. I have all the new parts in. I got a new suspension, track, air fuel gauge, water temp gauge, and nitrous regulator but I need about 2 or 3 full days to get everything done. I also have to fix my cool down cart.

Out of town next week. Maybe get it going end of May.

 

[mahaman]

We are running an '06 APEX with a a mid-mount MCX race kit - 30 lbs of boost, new pro-line rear skis, boost controller, lightened significantly, crank, carillo rods, JE pistons, cams, valves, etc, etc, etc.

Been too busy to get to the track but hope to in the next week or 2.

 

[ride -4-fun]

i'm putting my fx nytro on the tar very soon ,just finishing it up .... going to be running at nyirp probably...