Latest activity

What's new Featured content New posts New media New media comments New showcase items New showcase comments New profile posts Latest activity
  • G
    GT Mills replied to the thread Why is my Boondocker ic blocked off on the carb side?.
    When I raced GT1 in my old 500HP, 1800# Porsche 930 in the early 1990's we discovered that the big Garretts we were using designed for...
  • MrSled
    MrSled replied to the thread Phazer stalls at idle; Intermittent.
    It could be a sticky valve or the throttle body is just that dirty since you had injector sticking.
  • steiner
    steiner replied to the thread The Covid Escape Room.
    • Screenshot 2025-09-25 075209.png
  • T
    TJF1972 replied to the thread Wind Deflectors.
    Anyone happen to have a file to 3D print the gt wind deflectors?
  • S
    STAIN replied to the thread Quebec trail pass.
    i just purchased my Quebec early pass. Hopefully I can go 4-5 times
  • BADSLED
    BADSLED reacted to Fleecer's post in the thread Testing with TD GPS/Dragy with Like Like.
    The only way to run yellow at 60 is with xs825, straight FACTORY 35, and lighter weights. My bad....I should have specified. With your...
  • Mooseman
    Mooseman replied to the thread Quebec trail pass.
    I just read that the MTO has denied the OFSC a 7% permit fee increase. And because of this, I just found out that the OFSC are cutting...
  • jonlafon1
    jonlafon1 reacted to Srxspec's post in the thread Ulmer Dyno with Like Like.
    STM aggressive profile, same weights I use in a Yamaha.
  • jonlafon1
    jonlafon1 replied to the thread Ulmer Dyno.
    100% . I was running a STM helix and have some post on here somewhere. I showed the difference with a angle finder. Knapp kind of...
  • jonlafon1
    jonlafon1 reacted to Srxspec's post in the thread Ulmer Dyno with Like Like.
    Dalton helix will match OEM Yamaha angles. STM will be 6 degrees steeper. If you bought a Dalton 35, it will shift virtually the same...
  • jonlafon1
    jonlafon1 reacted to Srxspec's post in the thread Ulmer Dyno with Like Like.
    Sorry, I should have stated STM Yamaha helix angles vs OEM Yamaha helix angle. If you use a STM 39/35 helix on a Sidewinder secondary...
  • jonlafon1
    jonlafon1 reacted to Srxspec's post in the thread Ulmer Dyno with Like Like.
    My clutch recipe has changed in the last few years. I have gone to an aggressive profile matched with my soft primary spring, steep...
  • jonlafon1
    jonlafon1 reacted to STAIN's post in the thread Ulmer Dyno with Like Like.
    The reason I ask is because when I ran the TAPP on a couple of different sleds with different tunes, I felt like the sleds where...
  • Mooseman
    Mooseman reacted to thrasher's post in the thread Quebec trail pass with Like Like.
    I don't think that Ontario has a problem of pricing our trail passes to low. I think they have an allocation of resources problem. We...
  • sideshowBob
    sideshowBob reacted to RobX-1's post in the thread The Covid Escape Room with Haha Haha.
Show older items


Back
Top