Recent content by Chris Hammer

Thanks for the prompt reply. Do you have a image of the 8 ground block locations? From the harness I only see 2. I did replace the harness with a new used one just recently. I know the bottom of the middle jet, there is a rubber o ring that sits on bottom of that and goes in the float bowl and...

Hi Rockmeister, the only 2 spots or blocks that I found was on the starter and near the front of the hood. The self diganose system won't flash codes atm...I checked the TPS, resistance is good and moving thr throttle is is between 0 and 4k ohms, coming up at 3 ohms. Still bogging near half...

Update: got spark now, took sled for test drive and it will not get past 1/4 throttle without bogging down. Carbs were just cleaned and in good shape. Hand wamers were getting hot and even if I turned them down. By passed the TORS and no difference. Switched out 2 other CDI's and voltage...

Yes, cleaned them up, switch back to the OEM stator and a newer CDI and I finally got spark! Butttttt now sled is bogging and hand wamers are hotter then hell, won't stay on low. Check engine light is on and other orange light with "!" mark.

Hey folks, still have an issue with my 04 warrior. Replaced stator, coils, plugs, CDI, and a used wire harness. Still have no spark. Sled was checked over by a mechanic on the kill switches and everything out. Stator is good. Looking for anymore ideas what to check. Where are the main grounds...

Hi goto802, where is your crank sensor on your motor? Do you have a 900cc engine or the 1000cc one?

I have a 04 warrior with no spark. Last season I was driving and I kept blowing the main 10 amp ignition fuse then I lost spark totally. I replaced the stator with a good new one and had no luck. I replaced the wire harness today hoping this would fix it and nothing...Engine cranks and all...

Hi, yes set ohms at the lowest value (20) and pick up coil was at around 220 ohms, the stator it's self was reading at "0" across all three wires.

Thanks, so just reverse the 2 wires for the pick-up aka trigger coil? Trying to see what you guys mean about trigger!

What do you mean by trigger? The pick up you mean?

Hi, I used a aftermarket part, new.

Hi 03RX1-ER-LE, it was from Kimpex which is made in Quebec Canada, it was $ 180 CND, probably made in China like the rest of them! As far as I know, there were no problems with this stator though I will contact the person I got it from. Still seems weird, I drove it into my shop when we had...

Hey guys, got a 04 Rx Warrior. Just replaced the stator and pick-up on my sled. Before that I had the sled running in the winter but was blowing the main 10 amp ing fuse. Now, after putting it all together, I have 0 spark? I tried all 4 ignition coils and checked plugs. I also just replaced...

Thanks, craigreavley for posting. I am running into problems with my stator I think and want to change it out. Your pics are a lifesaver, I have a 04 LE 136" warrior, new to 4 strokes and this form. Looks pretty straight fwd. I found out on this form, to use the snipping tool for downsizing...

Hi Adrakisz, was the stator hard to change? Lot's to take off?