Recent content by nytro rtx se

Lil over 16000 miles

My 4 strokes don’t ever touch water or rocks , that’s for the ol 2 strokes. Centre cylinder connecting rod bearing went and put a hole in the block which sucked but was great to have the red beast back up and running.she was ripping with 280 studs and 300hp there ain’t nothing like the good Yamaha.

Yup up here in Nunavut northern Canada , people drive till around second week of June. I usually put my sleds away around end of May and use the quads. I already put mine away as I’m back at work in a gold mine. One year we were driving sleds till first week of July we were water skipping lake...

Won our ice drags the other day was fun races.

Big thnx to you guys got it all figured out , managed to win the ice drags the other day as our races are taking place right now.

Hey guys , My 17 sidewinder xtx 137” motor went I finally got my replacement installed got a used one. Engine is all installed , except it’s been apart for so long I forgot where the battery negative wire goes to from battery. Also where does the green antifreeze line from antifreeze tank and...

Would you know where I can order one , I’d like to see if it could fit.

Hey guys , anyone know where I can get a locking gas cap for sidewinder I know BRP has some not sure if they fit. Is there some for Yamaha/cats ?

Well see how long your last , every Polaris and skidoo around here blows there engine , plug eaters, belt eaters, and most can't last period. Don't get mad if you need a tow once your rush blows or acts up. A lot of us Yamaha riders don't care about MPG we care about the reliability and...

That looks like a great set up , I had the 4th wheel kit from ulmers and 2 outter wheels just bolt on stock shaft, which ends up using very long bolts to bolt on. One side ended up bending and the other side sheared off where spacer ends when doing a big jump landing with a bit of a wheelie, so...

Allen Ulmer did the clutching for best quarter mile set up , he also machined for OD on both clutches set up for 8DN and running 21/41 gears The thumbs up goes out to Allen as he did all the tuning all I did was install and drive :) When I took out transfer blocks off I put just shaft alone...

I run the 14 rtx se 129" with 1.25 rip saw 2, studded with 6 & 4 pattern with 1.625 ice chisels running 10" Woody carbides, Corners well don't push at all . I recently took out 2 coupler blocks off and found was better with them off. Rips like a freight train, just wrapped up our sno drags on...

my hindle got loud after a year or so of driving with it as well, Way louder then excel on my old nytro.

Was out for a drive yesterday , did a pretty big jump and kind of a flat landing sled was fine. However when I shut sled off for a bit then go to start it, P-1692 was on and flashing R along with the beeping. Looked it up and was forward relay low circuit. Had me pretty bummed out for a bit. So...

When you tapped into the cig lighter did you solder the wires and or use heat shrink? Seems like a nice set up I might have to copy yours.