Recent content by TT

Thank you very much!

Can someone confirm that the dimension on the Apex XTX 146” 2018 are: 1. Driveshaft 30mm 2. Drive sprockets 2,86” pitch and 7 teeth hex 30mm/1.18” ID Need it cofirmed before orderimg parts - Thanks in advance :-)

Are you using a "wire" style air filter? Looks like it is collapsing during the long pull and making the prefilter getting sucked in. Is it making you "starve" for fresh cold air and heat soaking the turbo?

What year mtx skid?

Is there any info if it is possible to install a 146" tack with 2.5/2.6" lugs together with 2.86 7 tooth drivers and offset rear axel with 9" rear wheel? Or is set back of the skid, rail extensions og Iceage rail the only option? To my calculation I need to take up approx 46.4 mm or 1.83"...

The updated ROV kit is a step in the correct direction. But dumping the vent hose into the air filter over the clutches is not a good solution. It will def. need a extended vent hose from the ROV and a catch can. So there is no doubt we a looking for a permanent solution from you Travis!!!

Got my kit today - according to install manual it is same location as 2020

Recall or sled still under warranty?

Any updates for us that needs a working ROV consept Travis?

I wish they just had a catch can instead of dumping it to the intake. A working ROV setup is needed in the mountains or while boondocking

x 2

I hope you are not correct. I have contaced a local dealer i Norway, Europe to see if they have any information from Yamaha Norway.

Arctic Cat also has a part # 0637-533 for a kit. I have ordered it from Country Cat. It is a kit that supposedly include parts from 1-13 in the picture

To my understanding it i a complete kit. Arctic Cat also has a part # for a complete kit to convert pre 2020 sleds ro the updated heated ROV. AC part # is 0637-533

Agreed!