Search results

Can’t do the camping but should be up Thursday night also. Looks fun

Hey mills have fun tell Doug Adolf hey for me if your in his group. It’s a long day

This is what I use on my skid steer zerks that stop taking grease

You will need both upper and lower a arms and new shocks for the 42 front end

I have a 2015 xtx and have been told the mtx coil over will fit right on i am planning on trying the coil over in the rear with a 160lb front skid spring and floats in the front with chambers for next year

I used a channel locks and bent the clutch guard down about 3/4” in down about a 1/4”

Also should be checked with bars turned and straight

You should be 0 when your not touching throttle and 99-100 when full throttle. I will have to look when I get home but I think it’s with sled power on not started hold bottom left and right buttons and it will pull up diagnostics then scroll threw to tps

Are you asking about the tps system? In diagnostic mode you can check throttle position from 0% to 100%

Thanks to mr. sled and frank the tank I can only imagine the amount time and work it takes to put that together. Thanks to all the vendors that donate doesn’t seem possible without them. Thanks to all the members provide great info

2010 RS Venture I Have been looking for a two up sled for some time and a 2010 rs venture has come up for sale near me wondering how they are, what to look at and some opinions on the sled in general. I currently ride a 2015 viper this would be more for when my wife or daughter wanted to ride or...

its easy to take out about a ten min job I would think you would have the new back in in about that time also

Could also be the skid is not in the right spot lower front and middle back Edit xtx issue

combs i would take a look at a parts diagram like babbitts or what ever that will show you were the clips and washers go inside the chain case its about the best way to find out wear all the parts should be

Got a pick. I’ve read about about people saying this I think mines ok everything meshes ok but curious as to were the bad spot on these are.

6400 and some change. Just about to reassemble the chain case and noticed a ball was real lose and ground flat on one side

Thanks guys had to pick up a new bearing pulled but it’s out and bearing was definitely toast.

dang thats what i figured someone would say. did the wobble bearing come out with the collar and shaft then?

I’m trying to release a stubborn threaded collar on the wobble bearing and it’s giving me fits.I have already damaged it or I would try and thread the nut back on to beat on but can’t at this point. I’m going to try and heat it tomorrow and see if it will release. Wondering if anybody has any...

Hoping to be in tomorrow morning