Search results

I'm keeping my Warrior too. Only 1500 miles this season so far & its just broken in. I too installed a temp gauge & rear cooler & now it runs fine in any conditions. I'll consider purchasing a 06 if there are significant improvements, EFI etc.

I saw 117mph (dream meter) on hard pack/ice last weekend while checking out new cooler on the warrior. I have stage 1 clutch with 162 studs & secondary at 80 deg. I was racing a modified Polaris 800 jetted, piped,team clutch, primary clutch machine trued, different weights & studded. I beat...

My warrior's tunnel protectors extended into the tunnel extension. The heat exchanger would not fit flush up against the extension with them in place or line up with the holes . I didn't remove the skid frame so had to enlarge the hole on each side, although we were able to remove the old...

I had to cut off about 5" of the tunnel protectors & enlarge the holes on the sides of the tunnel to allow the coolant tubes to go through on my warrior. Other than that it was a bolt in installation, took about 1 1/2 hrs. Well worth the trouble ...no overheating now, even in very marginal...

Greenmachine: Did you look at the drive belt protection on the mach Z. Looked to me that if you blew a belt it would take out the side panel & maybe come through to the rear & damage your left leg (unless they removed some protectors/shields for the show). I too agree the Fusion doesn't...

I spoke with the Yamaha rep at the Toronto snowmobile show yesterday about my overheating problem. I told him I was going to install the mountain heat exchanger & he told me that it should cure my problem & further advised that the 05's had the problem cured. In prior conversations at other...

I too am suffering from overheating with my Warrior. After the overheat light comes on & I get it to turn off by running in loose snow & travelling about 1/2 mile with the light off I have found that it will not rev past 8000- Rpm. It will rev up to that rpm & no more, I back off the throttle...

I have only 1400 miles on my track but I inspected it last week & it is still in exellent shape. I have 162 studs in it & run in all sorts of conditions Hope it doesn't start to deteriorate after 3000 miles like yours

Nice neat setup!! Great location of the fuel shut offs too. :P

SrXxTrEeM You don't really believe this government any more than the last one do you??? :wink: All their promises are to be taken with a grain of salt. :lol:

A GREAT post, contains lots good information from some very experienced riders. Suisse have an enjoyable safe trip, I'm sure a lot of the guys/girls reading this thread were going with you.

canuk heater KMER Everyone should have a "CANUCK" block heater :wink: Keeps OUR motors warm :D [/b]

Wiring short Buckeye, thanks for the pictures. Thanks also to Kmer & Rxwonder for the help. I plan on tearing the machine's wiring apart to-morrow to get 12 v (fused) from the battery to install GPS & wiring for heated visor I'll certainly be checking to see if there are any possible...

Snow site And we Canadians could use a site like this (our weather people leave a lot to be desired for accuracy :cry: )

Before the site crashed there was a thread about moving the wiring on the steering column. If memory serves me a wire rubbed though & left a few people stranded on the trail. :( It was a pretty simple fix but I don't recall which wire was moved either to the front or back of the...

Has anyone tried the Belt-Aid product? It's advertised in a few of the snowmobile magazines, American Snowmobilier etc. Its a device that goes on the secondary hub & allows you to open the sheaves easily to change a belt. $39.95, fits Yamaha & Arctic Cat reverse secondaries...

coolant hose Smokey Thanks for the tip on cutting into the coolant hose. You're right I just presumed the hose Rxwonder was talking about was the one running down from the thermostat housing. Hope I didn't give him bad information.

coolant hose The Mechanic ran the 110 v wire between the shroud you were working on & the frame back to the footwell, into the footwell & the plug is stored in the rounded rectangular opening above the footwell Its a snug fit so I can't see it falling out. He kept the cord short so it...

coolant hose I just picked up my new warrior(yesterday) & I had a "block heater" put in it. ($35.00) I goes in the same hose you punctured. The mechanic jacked up the back end removed the black cover at the rear of the running boards & removed the plug at the centre of the back. He filled...

Map Tank pag Warrior Will the map bag separate from the tank bag or is it all one piece? I like to put my valuables/cell phone etc. in the tank bag & take it off the machine when we go into resturants etc. :wink: