Search results

I was wondering if anyone experienced their engine cutting out under throttle. I was cruising at 40 mph and it felt like I ran out of gas. I pulled over and as soon as engine was at idle it was like nothing was wrong. This happened several times throughout the 120 mile trip. The engine runs...

I have put in 2 factory batteries and they both died and couldn't be saved. this all happened in the 1st year of owning my brand new 2018 sidewinder. I brought it in to shop so they could check the sled out to see if there was a draw causing the dead batteries and they found nothing. I then went...

I know I asked this before but I'm hoping someone else has the same issue and a solution. I keep finding antifreeze drips on my frame under clutches. I can see a drip on my stub shaft housing but cannot see where it's coming from above. I tightened all hose clamps that I could see but still...

I removed the tensioner and tack welded the screws on the roller. I put the tensioner back in and put the adjuster back where it was but it looks loose. what is the correct tension on the chain

I was wondering if anyone was using amsoil severe gear 75-90 synthetic oil on their sidewinders? if not then what is the best chaincase lube to use? Thanks mike

I am looking to address the spinning bearing problem on the driveshaft while greasing the bearing. What i'm reading here for the best fix is to tap the shaft and use set screws and bearing loctite to secure the bearing. I was curious if anyone has done this without removing the skid. I was...

I know I've read here about others have antifreeze leaking on their new machines. I noticed several drips on the frame that the oil pan cover attaches to. It looks like it's coming from behind my primary clutch. I tightened the hoses but it still seems to get drips. Any ideas? Thanks mike

I have a 2018 sidewinder which I installed the hurricane race bundle in ( 240,270,290 ). I also have the hurricane trail muffler which makes these tunes work perfect. I ride in Maine where the wardens are all over sleds with turbos. They want to see the exhaust and see if it's been modified. I...

I installed the 240,270 and 290 race bundle on my 18 sidewinder this year. It works unbelievable and has so much power. The only problem I'm having is the flash to pass button only works when it wants to ( usually for the 1st 30 minutes or so) then it won't shift through the tunes unless I do it...

I was curious to why the weights bolt and nuts are to be torqued to 4 pounds. Would it matter if I just tighted them up real good? They still have lots of wiggle room. I read somewhere that they should only be hand tight.

I have the pilots on my 18 sidewinder 137 . I feel the dual runner doesn't truly work for me. I have lots of push in corners and etc I know that I am actually only running on single runner until I turn but it feels like the outside carbide does very little. What are others using on their 6.9...

Hello everyone I have a 2018 sidewinder which I have installed the hurricane tune bundle on . This included their high flow trail friendly muffler. This set up is not at all loud by any means and imo the same as my apex I have read on different posts that up in Maine the wardens are...

I bought the hurricane race bundle which came with the weights and trail muffler for these high hp maps. I was installing the new muffler and noticed the inside flange bolt hole to be too close to the exhaust connecting to it( this would be the 90 degree bend before the flex portion of the pipe...

I am trying to decide on flash options for my 2018 sidewinder. I truly like the hurricane flash bundles they have but can't decide between the stock muffler 225hp, 240hp, and 270hp and the trail muffler and header, 240hp, 270hp, and 300hp. Or drop the header and run 240hp, 270hp and 290hp tune...

I had to remove 2 mm off the shaft of secondary to get to 60mm I was wondering if I need to remove 2mm off of spacer behind bolt that holds secondary on.

Hey just a quick question. I had to machine 2mm off secondary clutch shaft to be right according to the Hurricane clutch tool. Now I'm wondering if I would have to machine the spacer that holds the secondary on? Mine did not have any washers with it like others have on their sled. Is this...

I have a 2018 ltx dx that I bought at end of season last year. I have been trying to follow all the posts concerning the clutches and belt blowing and changing the stock set up to remedy this issue. So far I had 2 mm removed from my secondary shaft and changed the secondary spring to blk/orange...

Can anyone help answer a question I have on my sleds rear suspension? I recently changed my slides to get an early start for next season and after adjusting track I noticed when I pushed down on rear bumper the suspension would compress but would not return upward. Sled has 900 miles on it with...

I own a 2007 apex gt attak. I replaced the worn slides with a set of dupont ones. After I reinstalled the rail / suspension and adjusted the track tension I noticed while pushing down on my rear bumper and compressing the suspension it didn't return to the Original height. My sled has 900 miles...

Does anyone have 07 attak with rear exchanger? Does anyone have this exchanger that has damage from kicked up snow ? Do they make a protector?