Search results

So I about have my sled a part enough to modify the front cooler for the 3 incher. Is it worth it in the end? My plan is to modify the front cooler similar to Nikolia. Will I be able toget enough room my clearance is 2 and 7/8 inches. I am planning the starter notch the frame cross bar is...

Thanks OTM I will check if its aluminum or steel this week. When sizing up the new rear do I need to do anything with the limiter strap? Is that not an issue when initially setting it up? mckinney

Thanks got the part ordered last saturday and went to pick it up friday and they couldnt find my order. They reordered and rushing it. Thanks Hope cat guys dont have issues getting parts lime I am.

I just got a barely used cat 153 going to put in my 08 Nytro. The rear shock is a fox air but there needs to be a spacer or bushing at both rear shock mounts. It has the rubber in the shock both ends but pretty sloppy. Do you know what the specs are on this bushing? Thanks mckinney

A few years ago I talked with skins at the snow show and they mentioned getting the rider as forward as I could. So I took my oft steering riser and put the bottom hole of riser in top hole of frame and that gave me a better steering angle. I know Nikolai's machine is different but stockers with...

Yes, I have been checking that out too. Ulmer used to have a kit to remote mount oil filter. Want to tunnel mount cooler to remove front cooler, but I have older push turbo and it eliminated the factory tunnel cooler to mount charge tube on that side. So I will have to look it over and see if...

On the AC spindles are they taller from ground to the mount on the bottom a arm? Whats the reason for using them?

I ran it around and pushing 8 lbs boost. Gonna take it up again and see if I mess with controller settings if I can tell that it runs different. It had no stutter and ran great didn't push too hard to get to boost much. It is the gen 3 controller.

This is the plug.

I have a older push turbo fuel controller with an injector plug. It doesn't plug into the injector as the Dobeck site shows. Any idea do I need to use this plug? mckinney

Just wrapping up install older push turbo and cannot locate the plug for power to the controller. It has white and red wires. I believe it is power cause I don't get light when I turn on key. Ok looked up Dobeck controllers it is an injector wire, which injector should it go to? Does it matter...