2008 Phazer MTX Clutch Info

[promelas]

I've got a 2008 Phazer MTX and am looking for information on clutching. My understanding is that the factory clutching is for riding at elevations of 8000 - 11 000 ft. The current weighting is top hole open, second hole has a rivet with the center drilled out. My home area is only 1800 ft in elevation so if anyone has a clutching chart or knows what the weighting is for 2000 - 4000 ft, I would greatly appreciate it.

Thanks

 

[Tbyrd]

phazer mnt only has 2 holes

in out
0-2500ft 13.9 13.9
2000-4500ft 13.9 13.3
4000-6500 13.3 13.3
6000-8500 10.3 10.3
8000-10000 none 10.3

 

[promelas]

Thanks Tbyrd,

I'm definately set for 8000-10000 ft so I should get some extra pop once I change this out. Did these weights come from the repair manual?

 

[Amo]

I'd look for the weights in the 47.9-48.1 range...total weight. I run 48.1g at 1000ft and am going to 48.5g next cause I still hit the rev limiter a bit at times. My 10k wieghts were 46.4g for reference and they were too light so I went to 47g and that was really good for Togwotee.

 

[Tbyrd]

yes. right out of repair manual specs.

 

[darens]

What is the stock elevation setting for these sleds? Or is there even one? I seem to hit rev limiter all the time and I am at 200'.

 

[promelas]

My understanding is that the factory setting is 8000-10000 ft. So unless the dealer it was purchased from changed the weighting it's probably set for that elevation.

 

[Amo]

Darens,

If you are that close to seas level, look for the heaviest rivets you can get, you'll be much happier...

 

[darens]

2685ft, now that sound better. I thought 200ft sounded completely wrong, I was looking at the wrong spot on the page. Must be Monday, nope its tuesday