kinger
VIP Member
- Joined
- Jan 17, 2005
- Messages
- 7,403
- Reaction score
- 1,539
- Points
- 1,963
- Location
- Clear Lake, IA
- Website
- www.piergenius.com
For what its worth I had ARP head studs and removed them and went stock TTY bolts when I had to swap the head early on by Ulmer. Good luck!
- Joined
- Apr 17, 2003
- Messages
- 5,460
- Reaction score
- 1,257
- Points
- 2,003
- Location
- Menno, SD
- Website
- www.ulmerracing.com
- Country
- USA
- Snowmobile
- 2014 Yamaha SR Viper LTX, 2014 Yamaha SR Viper RTX SE, 2015 Yamaha SR Viper MTX SE 162 (turbo), 2015 Yamaha SR Viper MTX SE 153
- LOCATION
- Menno, SD
- WEBSITE
- www.ulmerracing.com
Theoretically, by doing the math, you should be able to run 28ish lbs of boost on Q16 with stock compression. I've pulled a rod out of a motor that was bent like an "S" that never ran over 14 lbs (thank god it didn't snap)! Your fuel & timing will need to be perfect and make sure your fuel is sealed and fresh (not dead fuel) at 20 lbs.
