chain case lube

[new rob]

where should lube read on dip-stick with reverse?? is a little more better ?? it just dosen't seem like much. i'm in between arrows with dip-stick fully in.

 

[APEX 06]

It should be 8.5oz, midway it the STD side of the dip.

 

[VectorLTX2012]

where should lube read on dip-stick with reverse?? is a little more better ?? it just dosen't seem like much. i'm in between arrows with dip-stick fully in.

I would say follow the manual and you you will be fine. The oil capacity isn't very much 0.25 liters (slightly more that 8 oz.)

Chester

 

[new rob]

i'm 1/2 way on arrows on reverse side which is lower than standard side should i add more ??? next year i'm measuring out 8.5 oz than adding

 

[MacAttak]

I've always put in 250ml, it is written on your belt guard.

 

[Irv]

i'm 1/2 way on arrows on reverse side which is lower than standard side should i add more ??? next year i'm measuring out 8.5 oz than adding

Imo, that is not enough.

Use 8oz's and it should come pretty close to the top of the arrows on the standard side.

Check it after a good run and after it has sat for a while.

Too much oil is just as bad as not enough.

 

[rayone02]

I need to add some to mine cause I filled according to the manual. So dont use the reverse marking just use the standard?

 

[VectorLTX2012]

i'm 1/2 way on arrows on reverse side which is lower than standard side should i add more ??? next year i'm measuring out 8.5 oz than adding

If you have reverse you need to read the dipstick that says "REVERSE". If you don't have a reverse you need to read the dipstick that says "STD". The REVERSE side is indicates a lower on the dipstick. This is according to my service manual.

Chester

 

[Irv]

I need to add some to mine cause I filled according to the manual. So dont use the reverse marking just use the standard?

That's the reading I have done on here, 8oz's regardless if your sled has reverse or not.

Can someone else verify this?