Got a code 12 today.....

[Sapling]

Anyone know where to start looking??

Looks like the code is the crankshaft sensor.......

 

[Sapling]

I had it running 3 times prior to this today. Ran fine. Went to start it again and got code 12 on the guage.

Any ideas.....???

 

[shiznitt]

i am trying to upload the service manual, sounds like you are correct on the code and the meaning,just make sure the sensor wire is not damaged and the sensor is plugged in, i have had and still do have codes that come up, if the sled stalls on a roll over or suddenly stops you will get a code. email me if this file does not come through i will send it to you colinp100@yahoo.com

 

[JIM]

un plug the rb3 and reset the codes. then re install the rb3. I had it happen to me.