Greasable Control Arm Bushing Kits

[Mainway Solutions]

Mainway Solutions Yamaha Greasable Control Arm Bushing Kit MYK01

• This kit fits all control arms from 2014 to current Yamaha Sidewinder, SRV, ARCS and QS3 Front Suspensions
• Redesigned upper control arm Stainless Steel axles to accept grease.
• Full support using Bearing Bronze Bushings with Stainless Steel Axles

 

[srvfan]

Nice! Shouldn’t have been that way from the factory

 

[Mainway Solutions]

Nice! Shouldn’t have been that way from the factory

Yes it would have been nice, But then I wouldn't have anything to do. I've been building these types of kits for a decade now with a proven track record of Product and Customer Service.

 

[Mainway Solutions]

Check out some of our other products

 

[mike800]

I just finished installing Val's A-arm/bellcrank bushings on my second Procross sled, a '17 with only 1200 miles I bought. I find they make a major improvement over the mass produced stuff that is stock. It's time-consuming like anything else on todays tight chassis but well worth the result. I didn't rush through it on this extra sled; put it on the lift and kept everything organized and cleaned as I worked. I put about 6 hours into it with lunch and beverage breaks and part of that time was drilling out the lower side panel rivets to add riv-nuts. Both my sleds have nice tight front-ends that work well. I recommend it.

 

[DennyTuna]

I agree, have had them on my sidewinder for a few years now and time to do the Viper. Bell crank bushings have been done for a few years as well. Super nice products from Val @ Mainway.