Handlebar Riser

[Wakegod]

What are some of the options for a handlebar riser for the 2006 Apex?

I did not do the handwarmer update with the 07 bars.

I do not want to have to worry about buying cable extensions. Hoping I can go at least 2" taller for a reasonable cost.

 

[Turtle]

What are some of the options for a handlebar riser for the 2006 Apex?

I did not do the handwarmer update with the 07 bars.

I do not want to have to worry about buying cable extensions. Hoping I can go at least 2" taller for a reasonable cost.

We provide fully polished billet bar risers. They also allow you to retain use of the stock chrome trim ring. Combined with the adapter block, a 6" riser will give you a total of 8.5" of rise (measured from the top of the steering column).
We also have an 8" riser available.

Check out link to our website in my signature below.

 

[WANN4STROKE]

I had a 2" on mine and it was setting off the TORS on tight turns-I talked about it here. I've taken it off for now-until I learn more about the sled. You may want to get cable extensions.

David

 

[bmiller]

I put on the powermadd pivot riser 3". Seems to fit fine but had to get rid of the cable holders on the bars. This is on an apex mtn. 2006 with handlebar update.

 

[Wakegod]

I had a 2" on mine and it was setting off the TORS on tight turns-I talked about it here. I've taken it off for now-until I learn more about the sled. You may want to get cable extensions.

David

My TORS is disconnected due to the supercharger. What riser did you have? How much was it?

 

[WANN4STROKE]

I bought it used.

 

[sledskiing]

PowerMadd 8inch risers and pivot. No cable extensions just run the throttle cable outside the lower metal bracket.

 

[bmiller]

I have just the powermadd pivot and used the stock yamaha riser. everything seems ok but not sure how it runs yet since I am in the middle of hooking up NOS kit