Need help apex with rx1 engine turbo

[Jessejukes]

New to forum and Yamaha 4 stroke

So I been digging into my new to me sled have codes
14
20
85
It’s a 2006 apex with a rx1 engine and turbo
Running all the apex fuel system etc

now the sled does not have the oil sensor because of the engine is there away to have it deleted so codes gone for ever
the air pressure sensor I thinks bad is there a way to test it

 

[mbarryracing]

The intake air pressure sensor is the same as the MAP sensor, you could always swap them and see if the fault follows the sensor or stays with the connector.
Might just be a broken wire at the terminal in the connector itself from getting moved around or tugged on since it's the one hanging out in no-where with a turbo install.

The oil pressure switch, I think, is just an on/off switch and not a variable signal sensor, so only makes contact when the oil pressure is below a threshold. I'd try grounding the lead to fool the sled into thinking there is sufficient oil pressure.

The RX1 engine starts and runs without a cam position sensor in the RX1 valve cover?