Need Studding Help

[Canadian Viper]

I have a 2011 Vector LTX and in the process of ordering studs. Woddys claim 1.325 is the proper stud. Stud boy,Fast Trac,claim 1.375 is the proper one. Which is correct? Do I need any modifications to my standard tunnel protectors? Any help would be appreciated.ThanksIs there a difference between 2010 and 2011? Just reading a post below me

 

[yox185]

The difference between the two sizes is only 1/20 of an inch. The reason they recommend those particular sizes is because that's what they sell. Both are good studs so buy what you like.

 

[IAVECTORGT]

Yes you will need additional protection because you WILL impact the rear cooler with EITHER size stud. If it was a shorty, than no, no additional protection needed with 1.325 studs. http://www.ty4stroke.com/viewtopic.php?t=88497

 

[Canadian Viper]

So it really doesnt matter which size, I will need extra protection with both
Correct?

 

[dexter]

check extreme max... sold at portyamaha, stainless and like 2 bucks including backer and nut!!!!

I have like 8k miles on mine and they are mint. dont waste your cash and check them out.

 

[IAVECTORGT]

So it really doesnt matter which size, I will need extra protection with both
Correct?

Yes! I have seen numerous Vector LTXs that had the rear exchanger impacted. Extra protection is fairly easy to install on these sleds.

 

[Vectornut]

I use Mack's studs with big nuts @1.325. My other studs tore part of the track out and poked a hole in the cooler. The big nuts don't break off or tare the track and I have not lost a single stud from Mac's in 2500 miles. On the other brand, I would loose 12 or so studs per season.

 

[Canadian Viper]

Thanks guys! Dropped it off today for first checkup, 760kms (live in ontario Canada) sliders needing replacement. Thought nytro,s were bad. Dealer waiting in dupont slides. Hope this helps