mcamzr
TY 4 Stroke Guru
Does anyone know the size or where I can get a O-ring for the pickup screen at the bottom of the oil tank. I am changing my oil and it is in pieces. Yamaha part # is 93210-24001-00 but all the dealers around me are out of store and ordering it $10 to $17 shipping for a $3 part. Thanks for the help.
Mooseman
I'm not all knowing. Post your question in forum.
- Joined
- Nov 3, 2009
- Messages
- 4,020
- Reaction score
- 1,037
- Points
- 1,733
- Location
- Greely, Ontario
- Country
- Canada
- Snowmobile
- '07 Venture MP (gone)
'07 Phazer FX (gone)
'09 Phazer GT (gone)
'10 RS Venture GT (My current ride)
'10 Nytro FX (son's)
- LOCATION
- Greely, ON Canada
All I can suggest is to bring the old one to an auto parts or a hydraulics supplies store and match it up. Or buy an assortment pack and try some different sizes. It should be about the same circumference as the bottom part of the tank where it goes.
poor farmer/logger
TY 4 Stroke Junkie
- Joined
- Dec 3, 2012
- Messages
- 543
- Reaction score
- 81
- Points
- 838
- Location
- Saskatchewan
- Country
- Canada
- Snowmobile
- 2015 SR Viper XTX 2009 Yamaha Nytro XTX
Have you had it out before? If not just reuse it. If you it's been out several times it's harder to get it back in. It does tend to swell some but with some careful persuasion you can put it back in again. It'll be metric I'm sure so the odds of the hydraulic shops keeping it in stock may be slim as well.
nitris223
TY 4 Stroke Junkie
- Joined
- Nov 18, 2012
- Messages
- 589
- Reaction score
- 32
- Points
- 778
- Location
- Yorkton Saskatchewan
- Country
- Canada
- Snowmobile
- Yamaha Nytro MTX
They are usually a stupid thickness as well. I have yet to have any luck with matching up any O-rings on any sled with the metric or standard o-ring kit. Most o-ring kits the rubber is thick. I think if you look at the bottom of the oil tank it fits into a recessed groove , so long as it fits there and is a tad bit thicker so it can compress and seal the hole you should be good to go.
NS FX NYTRO
Expert
I had a random O ring in my tool box that fit. Mine looked fine, but when I put it back together and started pouring my $15/Liter Yamahalube into oil tank and it pi$$ed out all over the ground, I needed to replace it. Go to local auto or hydraulic store.
