Are there any that can be done and what is involved. What else has to be done.With aftermarket exhaust.
Uni Filtereds air vents works good, just drill 6 1" holes in the lid. Im think on a Hauck fuelaccelerator to tune the efi.
Weapon X
TY 4 Stroke Junkie
Hey Thom I'm interested in this fuel accelerator, is it easy to tune? I got the Ulmer clutch kit and I'm installing a FMF slipon right now ,uni pods, wondering if this will all go together.
Hey! yes, it easy. Haucks recommendation for Pods and stock pipe or Pods and hauck dual pipe. Easy to install.
Snorkle?
This may be off the subject a little bit but does anyone know if there is a snorkle kit out there for the phazer? would love to got cold fresh air into the air box not warm moist air!
This may be off the subject a little bit but does anyone know if there is a snorkle kit out there for the phazer? would love to got cold fresh air into the air box not warm moist air!
A
Anonymous
Cold air intake from schmidt bros. put it in a "V" shape following that very top piece of plastic in front.
scooter1577
Veteran
Be careful with those uni pods I use them and the C clip melted into the bottom to hold in filter falls out and can go in your carbs. BAD!!! I lost a couple and were floating around in air box but didn't swallow them but I did suck one of the filters into the carb and it ate it. I've since drilled and safety wired through the bottom and pulled all remaining C clips.
scooter1577
Veteran
yes you are correct or the foam will get sucked in thats why you cut holes on the inside of pod and run a zip tie to hold both 
Prav
Pro
Snow Dust
Has anyone had issues with snowdust when riding in large groups. Curious on both uni filters and the d&d bullseye filters....
Has anyone had issues with snowdust when riding in large groups. Curious on both uni filters and the d&d bullseye filters....
The uni's that I ysed to run would clog all the time in any soft billowy snow conditions.
Prav
Pro
How about the DD Bullseyes??
Prav
Pro
Prav said:
what is the size of each one
BombaPolaYama
TY 4 Stroke Master
(I also asked this in the Phazer section) Has anyone tried this product from Ulmer - Phazer MOD Air Box? If so, is it worthwhile?
Thanks,
Thanks,
