Pulling hair out on ski alignment

[Mercer5]

Here's the skinny, 05 Venture RS, just replaced every single bushing, (15000 miles) in front end so I had all the steering out, tie rods, etc. Put all back in and now can't get full turn left, to much thread showing on tie rod ends have me freaked out. I have had tank off and adjusted shaft on bottom of steering shaft. It just won't even out...... I did have to put some new arts from a Vector in front end but I checked and all parts are the same, like tie rods.
I'm pulling what little hair I have left out, HELP!!!!!!

 

[steiner]

Misaligned splines on the spindles?

 

[Redbeard]

Here's the skinny, 05 Venture RS, just replaced every single bushing, (15000 miles) in front end so I had all the steering out, tie rods, etc. Put all back in and now can't get full turn left, to much thread showing on tie rod ends have me freaked out. I have had tank off and adjusted shaft on bottom of steering shaft. It just won't even out...... I did have to put some new arts from a Vector in front end but I checked and all parts are the same, like tie rods.
I'm pulling what little hair I have left out, HELP!!!!!!

Make sure the dots on your spindles and steering arms are lined up like steiner said.

If that checks out, maybe this post will help: http://www.ty4stroke.com/threads/steering-linkage-question.116508/#post-1098157

 

[Mercer5]

Yea, that's what I thought first, I thought I lined up dots but will double check
Thanks