Ready to Roll

[theCATman]

Ok curiosity got me,,,,,what is the catman setup for a vector

This is for LTX or 121" also. This is the same setup I use on my '06 Apex GT (121") save for the ability to adjust the shock electrically vs manually.

Depending on everyone's given weight & trail conditions more compression may be needed on the remote dial on the tunnel. PLEASE realize this.

1. Front shocks-- pre-load measurement of 1 7/8" collar to collar

2. Front shocks-- compression. clicker dial is 3 clicks in from full soft. In other words, turn it in counterclockwise 'till it stops, & then in 3 clicks

3. Front shocks-- rebound. clicker dial is 3 clicks in from full fast rebound. In other words, turn it counterclockwise 'til it stops, & then 3 clicks in.

4. Rear Mono-Shock pre-load-- Leave it in the stock cam notch. This should be the middle notch.

5. Rear transfer rod-- Turn the transfer rod IN to a measurement of 1 1/8"

6. Rear Mono-Shock rebound-- 3 clicks from full soft, according to the dial on the tunnel. In other words, turn it all the way to full soft & then 3 clicks toward hard. NOTE: the compression feel will also change as the rebound is set tighter for weight & trail conditions.

7. Some people have gone 1-2 notches tighter on the limiter strap. I personally have tried it & noticed no difference from the stock location.

REMINDER!! the rear setting can & will have to change some depending on your weight & trail conditions. This also will change the feel of the compression too.


This setup comes from an ex cross country racer who has forgotten more about setting up suspensions than most of us will ever know.

On a side note also. As we all know the stock Yamaha skis suck major balls. Dually runners in the 6-10" range are highly recommended. As are Snow-Trackers if you choose that route.


ONE EDIT TO THIS SETUP: Whenever my wife rides the sled, I put the Mono-Shock preload to full soft. She said the middle setting was a little harsh for her. She's about 125 lbs with gear. I don't think many of us guys here are only a buck-thirty geared up, but be aware that a light rider may want the Mono set on soft.

 

[theCATman]

In case you have measurement questions... here's pictures of front shock & transfer rod distances.

http://www.ty4stroke.com/attachments/p9150014-jpg.76744/

http://www.ty4stroke.com/attachments/p9150015-jpg.76743/