is there any way to greasethe outside wheels like the rest of the idlers by removing the seal? it looks like there pretty much a enclosed bearing w/no way of getting to it? thanks.
his suggestion is the stock wheels. i heard someone once tell me that they used a needle to inject grease n the bearing, think this would work? everyone of these da# wheels are junked and dry grease. its almost like they went 4 wheeling w/ it in the water and mud.
The ones I suggested don't look stock for my sled. They were stock for pre-RXes though. The ones I got did have removable bearings and did not need an extra bushing and very large washer. We are talkin' the rear axle vs an idler here. Right?
If you use a needle, you can get in there. however, it did not last very long. I suspect I was either to late or just opened the door for water.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.