RSI HAND WARMERS/GRIPS & RSI EPOXY

[NYTROFISH]

Just wondering if anyone has changed their handgrips...went with the RSI high outputs and wondering about wiring because they come with 3 wires...a blue, white and red and my wires are 2 blacks. Just wondering if anyone knows which colors I'll use??? I have a Yamaheater and Yamaboost hooked in. Thanks for any info or advice you can give me!

 

[Beenba]

I have the same grips and yamaheater also, with boost. I contacted rock and he said wire them as per the Yamaha instructions included with the RSI kit. If you need to know the exact config, i can look for you tonight.

 

[NYTROFISH]

thanks beenba i just ordered and may be ahead of my self but saw the 3 wires and got excited cause i hate wires.

 

[Beenba]

Its nice and simple to wire no worries. Rock also stressed when installing the elements (they have 3m glue on the back) take your time...use 2 people if you can, and ensure there are no kinks in the circuits. If you get a kink, that is where the grip is likely to burn out. I reused my stock Yamaha grips with no issues also.

Edit..while I was at it, i also spray foamed my bars because i've heard good things about it keeping the heat in the grips.

 

[NYTROFISH]

Thanks for the info...I will keep it in mind!

 

[jw440/800]

When I change rips whether golf clubs, bikes or sleds, I also use rubbing alcohol. It helps them slide on and drys very fast. It also helps the rubber grip onto the bars. Put some in the grip and slide it on where you want and wait a few minutes and your done with both in just a couple of minutes