spring settings on the secondary sheave

[kopenytro]

For some reason this Ulmer clutch kit install just doesn"t seem to be going right today. Primary is done and I have a question on the secondary.

When looking at the sheave that holds the buttons and spring and to which the helix attaches onto the secondary clutch. If the 3 holes on the outer lip are located at 12 o'clock high, is the spring hole that would be at 1 o'clock the #1 position referred to in the manual and the spring hole located at 5 o'clock the #2 position?

If this is correct, then my next question is do I need to rotate the helix approximately 70 degrees counter clockwise before mounting it onto the studs (6/1 setting as per Mr Ulmer) (or am i misunderstanding the how the manual reads)?

My sheave does not seem to have any markings or castings to indicate anything.

thanks again.

kope

 

[yox185]

The markings are there, just tough to see. One end of the spring in 6 (on the helix) other end in 1 on the sheave. Rotate the helix clockwise to line up the ramps and the holes on helix with the studs on the sheave.

 

[kopenytro]

Thanks Vox,
identifying the markings on the sheave is the issue. The helix is clearly marked. There is a very faint #1 looking symbol on the 1 o'clock positioned hole on the sheave but is is very faint and nothing else is showing up any place else. that is why i referenced the 12, 1 and 5 o'clock positions

thanks.

 

[shadow44]

this should help

http://www.ty4stroke.com/viewtopic.php? ... highlight=

 

[kopenytro]

secondary

Thanks Shadow,
I did a search looking for this earlier and did not find it.
I couldn't remember who had posted it.

This is exactly what i need.

Ps: Yox, thanks again and sorry for getting your name wrong.

Now I'm off to reassemble the secondary and then mount the 5.7 pilots i just picked up from a buddy.

Kope

 

[kopenytro]

Hey Shaddow,
one more question.
Allen told me to use the 6-1 position for my settings.
The thread said/showed that the setting being used was a 6-3. I can identify the marking on the sheave in the pix as a "G" which I have. This is the #3 position. So how many holes going clockwise do I go to get to the # 1 position Allen mentioned. 1 or 2.

Thanks again and sorry for the questions.

kope

 

[shadow44]

Kope, wish I could give you more help...I would pm NLVMAX or Turk..they'd be the best guys to ask...I just remember NLVMAX had pics of installing an Ulmer kit so I posted the link...beyond that your guess is as good as mine...sorry.

 

[yox185]

 

[kopenytro]

THANKS YOX!
You rock.

Shaddow appreciate the effort.
Thats why I love this site.