STX DX 146 Mount Locations

[Ding]

Can someone post the mount measurements of the STX DX 146 skid. I believe this came in both the Sidewinder and Viper models between 2016-2021? Basically I need to duplicate the geometry (drive axle to each mount CTC, and mount to mount CTC) in a different sled.

 

[Ding]

I'll settle for the CTC between the mount locations. If someone with one of the following sleds would measure and post, it would be very helpful.

2016 SRVIPER S-TX DX 146
2017 SRVIPER S-TX DX 146
2018 SIDEWINDER S DX 146

There are likely several others that have the same mount measurements, but I don't know for sure.

A neat idea would be to create a reference document or database with all of this info for all of the skids. I have a ton of this info on paper for pre-2005 skids, but not much since. I wish I would have started an electronic version as now I can't find anything.

 

[Zizgig81]

I'll settle for the CTC between the mount locations. If someone with one of the following sleds would measure and post, it would be very helpful.

2016 SRVIPER S-TX DX 146
2017 SRVIPER S-TX DX 146
2018 SIDEWINDER S DX 146

There are likely several others that have the same mount measurements, but I don't know for sure.

A neat idea would be to create a reference document or database with all of this info for all of the skids. I have a ton of this info on paper for pre-2005 skids, but not much since. I wish I would have started an electronic version as now I can't find anything.

I have a 2018 sr Venture dx 146. Would that work?

 

[Ding]

I was able to get the measurements I needed, thanks though.

 

[BADSLED]

I was able to get the measurements I needed, thanks though.

Can you share the measurements you found. Looking at possibly going with same skid..

 

[Ding]

I hope this helps………


From FA X&Y parallel to top of tunnel

S1 : X= 237.570mm Y=30.392mm

S2 : X=1107.401mm Y=22.148

 

[Ding]

And here are some pics of why (the bad) . . .

 

[Ding]

And now the good