TPS sensor

[4StrokeAddict]

Power Commander and Pod 300/computer software for me.

 

[cannondale27]

Power Commander and Pod 300/computer software for me.

You have to calibrate the pcv

 

[cannondale27]

How are you guys checking your tps percentages?

You can see it in diagnostic mode of dash

 

[fasteddie15x]

The 2014 prior to reflash would only show 80% no matter what u did. after the reflash mine would now show a 100% using the diagnostic screen on the dash. not sure why the engineers originally made it like that. so if you have a 2014 and have not had the reflash 80% is a normal wide open throttle reading.

 

[shadow637]

The 2014 prior to reflash would only show 80% no matter what u did. after the reflash mine would now show a 100% using the diagnostic screen on the dash. not sure why the engineers originally made it like that. so if you have a 2014 and have not had the reflash 80% is a normal wide open throttle reading.

I had the same exact results as fasteddie15x on both my 14's.

 

[cannondale27]

X3 Yup I remember that it was always low. Important thing is for the guys with PCV to calibrate the PCV to throttle then it wont matter what the actual # is since PCV will interpret the 80% as 100%

 

[4StrokeAddict]

I didn't know that. Will have to do some more reading. Didn't see anything about calibration in the instructions...

 

[4StrokeAddict]

How do you get to the diagnostic mode? I want to check mine now.

 

[cannondale27]

look for throttle cal on main screen

 

[cannondale27]

On sled guage hold both left and right bottom buttons I think.