wanted to find out what I should do .noticed that my track 1.25 ripsaw on my 04 rx1 had a stud tore out right in the middle of the track do you think it will be all right our should I replace,very clean tear thanks 
It should be fine, You might want to check every stud very close. Your lucky! When my stud tore, it only tore half out and as the track spun the stud hit my heat exchanger and poked a hole throuh it ending my weekend early. After repairing the exchanger I removed all the studs and ran it the rest of the season with no problems. I replaced it the following season and am not running studs because repairing the heat exchanger once is enough. Good luck.
Len Todd
TY 4 Stroke God
There is a company that repairs these types of tears. They are reasonable and effective. They do an excellent job. Try http://www.carrolltech.com
They have done a fix for me. I put a couple thousand miles on the repaired track. It was still good when I sold the sled.
If you replace the track, try an Ice Ripper. You'll never rip up another track by ripping out stud. I have one with thoudands of miles on. It looks almost like new.
They have done a fix for me. I put a couple thousand miles on the repaired track. It was still good when I sold the sled.
If you replace the track, try an Ice Ripper. You'll never rip up another track by ripping out stud. I have one with thoudands of miles on. It looks almost like new.
