brad gilker
Veteran
My 06 VK PRO starts and runs fine but has no top end, feels like it's running at 2/3 power.
Can get more the 60 mph. Cleaned carbs, changed plugs. Any suggestions. 6000 miles on her.
As to the rapid slider wear, I swapped out the original idler wheel for 1/4" larger diameter ones and now have 2000 kms on cheap Gamma sliders
Can get more the 60 mph. Cleaned carbs, changed plugs. Any suggestions. 6000 miles on her.
As to the rapid slider wear, I swapped out the original idler wheel for 1/4" larger diameter ones and now have 2000 kms on cheap Gamma sliders
brad gilker
Veteran
I think my exhaust donuts are pooched. Would that effect top end power?
- Joined
- Jun 1, 2004
- Messages
- 7,728
- Location
- sudbury on
- Country
- Canada
- Snowmobile
- 2016 apex xtx
2011 apex xtx
2009 phaser rtx/x
1997 et410t/r
1988 vk 540
it can affect it. if they are noisy replace them.
theyammyman
Newbie
I had a 2007 same problem cause was a broken secondary drive clutch spring.
Tunepipe
Veteran
- Joined
- Oct 5, 2014
- Messages
- 45
- Age
- 44
- Location
- Sormany
- Country
- Canada
- Snowmobile
- VkPro, Venture TF, Phazer, Snoscoot 200...Sidewinder, Excell III
Get clutches checked
brad gilker
Veteran
But sometimes it goes like an Apex, the falls flat on its faceI had a 2007 same problem cause was a broken secondary drive clutch spring.
Get clutches checked
Some times it goes like an Apex, then falls flat on its faceI had a 2007 same problem cause was a broken secondary drive clutch spring.
donuts done. No snow yet. It's for sale. Found a brand new 2016 for $12,500it can affect it. if they are noisy replace them.
- Joined
- Jun 1, 2004
- Messages
- 7,728
- Location
- sudbury on
- Country
- Canada
- Snowmobile
- 2016 apex xtx
2011 apex xtx
2009 phaser rtx/x
1997 et410t/r
1988 vk 540
ok. i was just going to suggest a new primary spring as my et does something similar when the primary spring is shot.