wahl extrovert install

[rx1tom]

I bought a set of Wahl extroverts for my 05 RX1 MTN, the only problem is the mounting instructions are not very clear. I was also told that I may need to trim the drivers so they do not hit the W arm. My questions are:

1. Does anyone have the measurements for mounting the drivers on the axle? If so please reply or PM them.

2. Do I need to trim the drivers?

3. For those that have used Wahl drivers, has anyone had any issues, I do not have a turbo or supercharger so I am not pushing out big hp.

Thanks in advance for your help.

Tom

 

[RXMax]

You do not need to trim as the rx mtn has the suspension set back. I have had no issues. Attached below are the measurements for the Wahl drivers on the rx/apex driveshaft.

 

[rx1tom]

Thanks SXMAX2,

This makes things a whole lot easier, how have the drivers worked out for you?

 

[RXMax]

Tom,
They have worked great. I ran them on my MM and now on my RX without any problem. I like being able to run the track loose! Good luck with the install.