New profile posts

Hello
I have 2013 yamaha venture snowmobile
And motor can run in neutral and when i hit throttle to forward its just keep just off even when i hit reverse throttle the motor just keep shut off its like it keep over gased or short gased
maim
maim
this should be posted in the rs section, not a profile post. look up reverse linkage adjustment as a place to start.
Hello..I searched about putting tuner skis on an apex and notice you have experience with them on an apex. You had a post years back that you used them with 6” carbide and liked them. Did you use 6” carbide on inside and outside runner? Which carbide?
Thanks
maim
maim
this should be a private messge (pm) to sgauthier, not a profile post.
Good evening! I got a set of 2009 nytro RTX FX shocks that need rebuild. Fronts are original fox float and rears have the reservoir. Is this something your able to still rebuild? Buddies sled we’re going through too to bottom. Thanks, Chris.
cannondale27
cannondale27
I sure can. Any issues known? Send them over with your Phone number. Will call when I get at them. Thanks
super1c
super1c
Can you send me your address I think I’m missing it in your profile. Also do you have a “rough” estimate for total rebuild and valve. No know issues that we know of, just updating. Thanks, chris
cannondale27
cannondale27
PM ed you
Anyone ever have a fuel economy issue with a 2014 SR Viper? I am currently on getting about 65 miles from a tank of gas. This is the same if I am riding WOT with the boys or riding a nice 20MPH casual pace with the wife.

Help I should be getting 140 miles from a tank of gas. And yes I burp the tank!
maim
maim
this need to be posted in the viper section of the forumn and not on your profile.

Did you secure that 24/50 set? I've had a 500 mile set listed on Hardcore for a few months...
Hello ... new to site... trying to find info for 2007 venture--- crank no start condition---no spark -- have power to coils so thinking problem on ground / trigger side.. control of power through kill switch on brown wires- has two smaller guage wires on kill also.. really need wiring diagram
maim
maim
could you as this question in the rs section as this should not be a profile post.
2021 SRX doing ARP head studs happened to have one pull the threads out of the block, going 65 ftlbs on the nuts I believe my torque wrench was not reading proper, anyone else have this happen, going to use a timesert and hope that does it. Any input, thanks
maim
maim
this should be posted in the sidewinder forumn, not on your profile.
  • Like
Reactions: MrSled


Back
Top