Search results

All, I cannot find, anywhere in the fiche, the black plastic part that the gage cluster fits into. Not anything on the guage cluster (meter) but the bezel that faces the driver that the meter sits in. Any help would be greatly appreciated. Glock

Used the mouth trick on the tube and it started in about 15 secs. Thanks all for your help, it is now a very Merry Christmas Ran it for a while and runs perfectly! Sled needs a cigarette as I nearly blew the gas cap off!

OK, I detached the clear vent hose from the frame, shot air in the hose with a computer cleaner air can and jammed my thumb over the open end. Cranked the machine for over a min. on and off....no go. Am I doing this procedure correctly?

I will try the vent hose trick tonight and repost either way. Thanks All.

Motor runs so it is not a stator. No relay on pump as it is carbed no EFI

Thanks for the help but that number no longer exists in the new catalogue (09). Or am I reading it wrong S not 5?

Has anyone installed a LH throttle on an RS Venture? I am looking to do this to eliminate thumb cramp on long hauls. Also, What is the exact size or part number of the oversize rubberized wheels that people are using to reduce hyfax wear and track noise. Thanks for any help. Congratz...

I am a bit new at this. Can you tell me the Yamaha part number so I do not order the wron ones? Thanks.

I just got off the phone with Woody's. I have had the same problem with either darting or poor handling. The answer I got was to install the new Woody's Dooly Slim Jim (P/N SY6-6580 for my 05 RS Venture) These have a deeper runner keel than that of previous models allowing for a deeper...

Thanks for all of the responses. How difficult was the installation with the Curves? Do I need an adaptor kit?

All, I have an '05 RS Venture with stock skis. I corrected all darting by installing 6" Woody's Doolys. I found that the sled did not corner well with these so I changed to Stud Boy carbides with shaper bars. My handleing improved dramatically but my darting came back. Has anyone found the...

Anyone else have excessive belt squeal after changing to a new belt? It is an OEM belt. Only squeals when stopped. No noise when engaged (moving). Thanks

Is there a grease fitting hiding somewhere for my jackshaft bearing or do I need to take this apart to grease it? Thanks

All, Looking to buy an '07 Attak GT. What will I need to know about / do to this new sled as far as recalls/bulletins or improvements etc. I am not looking for performance improvements yet. (Studs/pipe/etc.) I had a lot to have done on my '05 Venture before I was happy. Thanks.

Could someone send me or post the link to the excel exhaust? Thank You In Advance.

Hey All, I am looking for a performance upgrade pipe for my RS Venture. Anyone know of someone who makes these? Thanks In Advance.

My OEM 'carbides' saw 0 (Zero) miles on my sled. Were replaced with 6" Dooly's.

Personally I have had good luck with the following: 1)After first year of stock operation I burned through my hyfax quickly and encountered the howl. 2)After the season was over, I replaced the hyfax. I also replaced the wheels with oversized rubber wheels. 3)My track noise was reduced...

Probably waiting for parts-Thus the delay. Took them a while to get my jackshaft in.