Search results

moderator edit

85 kms right side bent, did subframe x-frame as done on race sleds still moved back then installed gussets,still moves.. if you drive across pavement to put gas in moves back and then when you reverse moves fwd.getting 09 summit.

had to x brace mine could n t trust the front end after i tweaked it.. no word from yamaha yet , i think a old 02 zx chassis doo is the next step.. 4 new yamaha sleds in 4 years , 2 new bikes one last year and one in 05. no troubles till this year and not to impressed.........

Last trip out to the lewis hills on the 15 feb-18feb. Ridding with the Lewis Hillbillies and Pics Taken BY Ronin aka Scott Grant. A unbelievable photographer.[/img]

everyone has to bring it into the dealer to show them there is a problem , i know of 4 here on the avalon in newfoundland and my dealer is in st.johns yamaha canada is not going to do sh--t about this ... so hopefully this doesnt bend and really hurt someone bad.

ditchbanger, Iknow a lot of guys have changed on there own ,but what did yamaha tell you about the track. tks

just wondering what yamaha has told you guys about the track folding over, mine has 350 kms or about 220 miles on it of deep snow , yamaha canada told dealer that it must be due to the fact that i rode it on hard pack and to look at the warning sticker on sled . Sled has never been groomed...

got a bent sub frame , going to add support, once back in place . Where is everyone putting the support. Very weak sub frame can be moved with 4ft pipe with little effort. this is not a very good setup. any help or pics would be a great help.

Is the front end damage only to the right side , mine is back, so is my friends mtx also, and another fx also right side.

ME TOO

picken mine up on monday morning

tks ski, dealer says sled will over rev, just wondering what is the top speed you get .

what did you do with the clutching.. soon to be newfienytromtx

just seeing if anyone left the 20 top gear and just changed the clutch weights and springs, and does this cause the machine to overrev .

thanks stoutner, just trying to figure out which nitrous system to go with and how big with just pump gas, looking at boondocker, boss noss and cold fusion any help you can give is appreciated.

you got any pics and is it mounted upside down.

sunk a rtx 2 winters ago, sucked up a pan of ice, down she went. lol took 4 oil changes and was good again

got it done , take off protectors put on doo extro drivers. changed gearing to a 20 top tooth.

got a powermad pivot and 6 inch riser on mine,no cable mods, still got the bar pad

heres mine