• We are no longer supporting TapaTalk as a mobile app for our sites. The TapaTalk App has many issues with speed on our server as well as security holes that leave us vulnerable to attacks and spammers.

Search results

  1. W

    Apex won't crank and no fuel pump

    With all this talk of burned grounds and connections, is this just a bad design with all the ground wires tying together to a single ground with no redundancy. Is anyone electrically savvy to know if it would be wise to run additional ground wires to ground or frame from some of these connection...
  2. W

    Apex - No start

    To start turn key to position 1. You should hear the fuel pump cycle...if it is super cold, it may not...this is frozen fuel pump relay...the one by your left foot...I kep a warm spare in my pocket always. Then turn key to position 2 to engage the starter. You should hear the starter. if you...
  3. W

    Sled torn apart - Any other maintenance recommended?

    I have 07 RTX. I suggest Excell Wheels from Barn of Parts. (stock wheels are too small causing premature slider wear) I suggest replace fuel pump relay with newer solid state one (07 older relay would condensate and freeze up causing no fuel pump click on ) I suggest clean or solder grounding...
  4. W

    First go on the Attak. Not what I was hoping for.

    If it was running good before you tore it down, I suggest it was something to do with the tear down. I hate to say it but you should go back in and check for pinched hoses (most likely) or missed electrical connections (these would give codes) You are not getting any codes?
  5. W

    First go on the Attak. Not what I was hoping for.

    Did it run bad and backfire before you changed the exhaust?
  6. W

    First go on the Attak. Not what I was hoping for.

    Did you check the exhaust gaskets? If you have backfire it is almost certainly bad exhaust gaskets...this site has write ups on how to repair these. 87 Gas is recommended for 06 in the manual is your rear suspension the monoshock or the CK?
  7. W

    steering spindle bushing replacement

    I have purchased the oilite front end bushing kit. Does anyone know how to replace the 2 bushings in the spindles?
  8. W

    she got a little wet...pls help

    The second topic of this site is "attack apex common questions". Go to that string and you will see the error codes. It will tell you which fault you have. Hopefully, just an unplugged sensor. Ratman
  9. W

    she got a little wet...pls help

    Do not just keep flushing it with 2.1 quarts... it wont work...I put mine under also. The apex exhaust is higher than the motor, and so you need to hang the sled from her nose and let the water in the exhaust drain out first. Otherwise you will keep contaminating the motor it as you turn it...
  10. W

    adjusting reverse linkage

    i am occasionally getting grinding when i put mt 2007 apex into reverse. Does anyone know how to adjust it. thanks:sled2:
  11. W

    Code 11 : /

    yes..i see it on the microfiche...i will check mine yhis weekend... thanks a lot:letsnow:
  12. W

    Code 11 : /

    Where is the starter relay... is it one of the 3 near your left foot? I will check mine also
  13. W

    Sunk my APEX Help

    Been there.. also 3 feet of water 1: Get sled into somewhere warm 2: raise front end to get muffler below engine, and turn it over to get most of the water out of the engine..not too long, as oil will not be good any more 3: I did 2 oil changes and filter change before restarting, and another...


Back
Top